44W102 DuraFire ™ Blue Markings Ink
MATERIAL SAFETY DATA SHEET

PRODUCT NAME: 44W102 DuraFire ™ Blue Marking Ink

SECTION I-MANUFACTURER IDENTIFICATION

Innovative Ceramic Corporation Phone: (330) 385-6515
432 Walnut Street Fax: (330) 385-6510
East Liverpool, OH 43920-3130

Prepared by: Orville G. Steininger
Date Prepared:01-27-2000

EMERGENCY PHONE NUMBERS (24 Hours)

Poison Control Center: 1-800-872-5111
CHEMTREC: 1-800-424-9300

SECTION II- HAZARDOUS INGREDIENTS IDENTITY INFORMATION

ACGIH TLV OSHA PEL NOISHA REL

Alumina Oxide (Al2O3) 10 mg/m3 15 mg/m3 Total dust N/A
(e) 5 mg/m3 Respirable dust

Chrome Oxide (Cr2O3) 0.2 mg/m3 0.5 mg/m3 0.5 mg/m3
CAS#1308-38-9 (A4)

Cobalt Oxide-(C03O4) 0.02mg Co mg/m3 0.05 mg/m3 N/A
CAS#1396-06-1 (A3)

Dipropylene Glycol Methyl Ether 606 mg/m3 600 mg/m3
CAS#34590-94-8

(A3)-Animal Carcinogen: Agent is carcinogenic in experimental animals at dose levels, by route(s) of administration at site, of histologic type, or by mechanism not considered relevant to worker exposure. Available epidemiologic studies do not confirm an increased risk of cancer in humans except under common levels of exposure.

(A4)-Not classifiable as a human carcinogen: Inadequate data on which to classify the agent in terms of its carcinogenicity in humans and or animals.

(e)-The value is for particulate matter containing no asbestos and 1% crystalline silica.

SECTION III-SYMPTOMS OF OVEREXPOSURE

Alumina Oxide-Acute inhalation overexposure may cause coughing and shortness of breath. Chronic inhalation overexposure may adversely effect breathing capacity. Direct eye contact may cause eye irritation. Skin contact may cause abrasions.

Chrome Oxide-Repeated or prolonged exposure to trivalent chromium compounds may cause delayed effects involving the respiratory system. Causes skin and eye irritation.

Cobalt Oxide-Prolonged inhalation of cobalt dust or metal dust, fume or mist containing cobalt may cause serious respiratory illness. Inhalation may cause an irritation of respiratory organs of sensitive persons resulting in obstruction of airways with shortness of breath. May cause serious eye irritation. Prolonged exposure to skin may produce irritation.

SECTION IV-PHYSICAL/CHEMICAL CHARACTERISTICS

Boiling Point: N/AV Solubility in water: Trace
Appearance: Blue liquid/paste Odor: Slight odor
Vapor Pressure (mm Hg): N/AV Specific Gravity (water=1): N/AV
Vapor Density (air=1): N/AV Evaporation Rate: N/AV
% Volatile by volume: Not measured Melting Point: N/AV

SECTION V-REACTIVITY DATA

Stability: Stable. Keep away from excessive heat or open flame.
Hazardous Polymerization: Will not occur
Incompatibility (materials to avoid): Strong oxidizing agents (Sodium hypochlorite, hypochlorous acid). Keep away from excessive heat or open flame.
Hazard Decomposition Products: Carbon monoxide, carbon dioxide

SECTION VI-FIRE AND EXPLOSIVE DATA

Flash Point: 302.8 F (calculated)
Extinguishing Media: Carbon Dioxide, dry sand, earth, dry chemical, foam or water spray.
Special Fire Fighting Procedures: Not a fire hazard. However, in the event of a fire, toxic fumes may be emitted. Wear self-contained breathing apparatus when large quantities are involved.
Unusual Fire and Explosion Hazard: None expected.

SECTION VII-EMERGENCY AND FIRST AID PROCEDURES

Eye: Flush thoroughly with water for 15 minutes.
Skin: Remove contaminated clothing, wash thoroughly with soap and water.
Inhalation: Remove to fresh air. May give oxygen if needed.
Ingestion: Seek medical attention. Do not induce vomiting.
If irritation occurs, obtain medical attention.

SYMPTOMS OF OVEREXPOSURE

Eyes and Skin: Prolonged or repeated contact may cause irritation.
Inhalation: Prolonged breathing of vapors may cause irritation of the respiratory system. Overexposure may cause lung damage.
Ingestion: Large amounts may cause irritation of the gastrointestinal tract, nausea, vomiting and diarrhea.

SECTION VIII-SPECIAL PROTECTION INFORMATION

Respiratory Protection: Use NIOSH/OSHA approve respiratory protection for organic solvent vapors where levels exceeds Occupational Exposure Limits.
Personal Protective Equipment: Wear appropriate gloves and goggles to avoid skin and eye contact. Safety showers and eye stations must be present in work area.
Ventilation: Use local exhaust or mechanical such as a dust collector to maintain dust, and vapor levels below the Occupational Exposure Limits.
Handling and Storage: Keep containers closed and dry when not in use. Avoid contact with eyes, skin and clothing. Store away from excessive heat or open flame.
Other Precautions: Avoid breathing dust, and vapors and use adequate ventilation. Wash thoroughly after handling. No eating, drinking or smoking in work area. Wash hands prior to eating, drinking or smoking. Practice good housekeeping, and personal hygiene procedures.

SECTION IX-SPILL OR LEAK

Contain spillage and scoop up or vacuum. Avoid dusting. Dispose in accordance with federal, state and local laws.

SECTION X-ADDITIONAL INFORMATION

The information contained in this Material Safety Data Sheet must be provide to every employee who is exposed to this product in any way. We recommend the user read and understand the contents herein before using this material. Please keep on file for future reference.

This product contains the compounds chrome, and cobalt. These toxic chemicals are subject to the reporting requirements of Superfund Amendment and Reauthorization Act (SARA) of 1986, section 313 of the Emergency Planning and Community Right to Know Act and of 40 CFR, part 372. Section 311/312 Hazard Categories: Fire: No: Reactivity: No; Acute: No. Section 313 Reportable Ingredients: This product contains 0.0018% Chloroacetic acid (CASRN 79-11-8).

This product is a mixture of various metal oxides, salts and some compounds, interfused and mixed with organic materials to form the final product which does not represent individual components. Section II, Hazardous Ingredients Identity Information, and Section III Symptoms of Overexposure, pertain to individual components. Section IV through Section X are in reference to the finished product.

The data set forth in these sheets are based on information provided by the suppliers of the raw materials and chemicals used in the manufacture of the aforementioned product. Innovative Ceramic Corporation makes no warranty with respect to the accuracy of the information provided by their suppliers, and disclaims all liability of reliance thereon.

Innovative Ceramic Corporation warrants only that its products conform with their published specifications, and no other express warranty is made with regard thereto. We do not guarantee favorable results, and we assume no liability in connection with the use of the products. Our products are intended for use by persons having technical skill and knowledge and they use it at their own discretion and risk.